Hell of a Barrel!

[X-Caveman]

I gotta ask... why the .X2 on every charge???

 

[Chris Mackey]

Nice, I like those targets, where can a guy get some?
Thanks
Chris

 

[WyleWD]

I have always preached barrels an bullets good job.
P.S. an the guy behind the steering wheel.

+1^^^

First off great shooting in 10mph switchy wind..

When you shot this did you shoot all of row 1 at once, then wait and do all of row 2 at once? Simply put, how much time do you allow between groups? Thanks. WD

 

[Ccrider]

Here is something to remember. Your gun shoots it’s best right up until it shoots it’s worst! For example 1B is only 1 to 2 tenths of powder from blowing up. The same with 2B. However 2B is just past blowing up and has 4 to 5 tenths of room before going out of tune. So my choice would be 30.42 and go shoot.

Row 1 is pretty much what I consider the low node. Row 2 is my high node. I could run over 3000 For a “Higher Node” but that’s where evil lurks.

Bart

What evils?

 

[Raythemanroe]

Ray

For load development I’m confident in taking this barrel to a match. I won’t do any more work on this barrel. Its ready!

Probably, I like to just do a small ladder at 1k just to because I do.

Ray

 

[shoot4fun]

Here is something to remember. Your gun shoots it’s best right up until it shoots it’s worst! For example 1B is only 1 to 2 tenths of powder from blowing up. The same with 2B. However 2B is just past blowing up and has 4 to 5 tenths of room before going out of tune. So my choice would be 30.42 and go shoot.

Row 1 is pretty much what I consider the low node. Row 2 is my high node. I could run over 3000 For a “Higher Node” but that’s where evil lurks.

Bart

Those evils that lurk in H4895 no doubt. They stuck a pitchfork in me at MSSA a while back. Now I'm working Varget and Gungnirs in the 6BRA.
Hope to see you at the range soon my friend!

 

[johara1]

Those evils that lurk in H4895 no doubt. They stuck a pitchfork in me at MSSA a while back. Now I'm working Varget and Gungnirs in the 6BRA.
Hope to see you at the range soon my friend!

I tried about 4 or 5 different lots went back to H4895.....I you find one that works let me know..... jim

 

[Ccrider]

Those evils that lurk in H4895 no doubt. They stuck a pitchfork in me at MSSA a while back. Now I'm working Varget and Gungnirs in the 6BRA.
Hope to see you at the range soon my friend!

Ok. I am slow. “What evils? Those evils that lurk in H4895.”

Again, I am slow. But not scared to ask. What evils?

 

[shoot4fun]

Ok. I am slow. “What evils? Those evils that lurk in H4895.”

Again, I am slow. But not scared to ask. What evils?

IMO, there is some inconsistency in H4895 lot to lot and I am quite sure I don't have the good stuff.
I shot two targets at a 600 yard in Memphis. An hour later (warmer) the same load was blowing primers and shooting patterns instead of groups.

 

[Stan Taylor]

+1^^^

First off great shooting in 10mph switchy wind..

When you shot this did you shoot all of row 1 at once, then wait and do all of row 2 at once? Simply put, how much time do you allow between groups? Thanks. WD

This is Bart shooting these groups hell I ain't steady enough to pull off that feat.

 

[BartsBullets]

29.82 and go

Only 15 FPS from disaster.

 

[BartsBullets]

+1^^^

First off great shooting in 10mph switchy wind..

When you shot this did you shoot all of row 1 at once, then wait and do all of row 2 at once? Simply put, how much time do you allow between groups? Thanks. WD

I would shoot 3 shots and go back and reload. So whatever that took.
Bart

 

[BartsBullets]

Those evils that lurk in H4895 no doubt. They stuck a pitchfork in me at MSSA a while back. Now I'm working Varget and Gungnirs in the 6BRA.
Hope to see you at the range soon my friend!

Lot to lot yes, but I haven’t found one yet that I couldn’t get to shoot. However, Varget is twice as Temp sensitive as H4895.
Bart

 

[BartsBullets]

I gotta ask... why the .X2 on every charge???

Say on 29.92, I’m going for 29.90 which the AutoTrickler stops on most of the time.

 

[pacer56]

Bart, how many rounds on that barrel?

 

[BartsBullets]

Bart, how many rounds on that barrel?

About 300

 

[BartsBullets]

Ok. I am slow. “What evils? Those evils that lurk in H4895.”

Again, I am slow. But not scared to ask. What evils?

No I Prefer H4895.

Evil lurks when you push a load to its upper limits. The higher and harder you push the narrower the load window gets. Then when the load blows up it does it so in spectacularly fashion!

Bart

 

[pacer56]

Thanks Bart,
Just got mine put together working on brass now as we speak.

 

[rwj]

No I Prefer H4895.

Evil lurks when you push a load to its upper limits. The higher and harder you push the narrower the load window gets. Then when the load blows up it does it so in spectacularly fashion!

Bart

Is this a good reason to perhaps choose a slower speed node?

 

[BartsBullets]

Is this a good reason to perhaps choose a slower speed node?

It’s why I do!