pros and cons? are the brass resized before or after you cut them?
hornady neck turning setup?
- Thread starter Doug30racer
- Start date
Shynloco
You can lead a horse to water, but ........
Good recommendation. I use the 21st Century Lathe turning tool which is the best I've found after trying several other, hand held turning devices that just didn't show me the consistency I expected.
And to the OP's original question, resize first and then trim of necessary. When you take brass and resize it, the process usually changes the shoulder and extends the neck further, leading to perhaps having to trim the brass. Doing this process in the reverse order accomplishes nothing.
Alex
Last edited:
Brians356
Silver $$ Contributor
Upgrades & Donations
This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.