need advice, stolle panda bolt issue

[michaeljp65]

Kelbly's is very good to work with. I understand the distance but you might find getting the correct spring from Kelbly's is the fastest and least expensive option. While you are at it you might consider a new firing pin spring too.

http://www.kelbly.com/contact.html

Would you believe that i need an export permit or some sort of licence for Kelby to send me 2 springs.
Whats the world coming too!
I had 2 You Dave trigger springs sent to me a few months back, no problems, not from Kelby's.

 

[A Marsh]

Sorry to have wasted your time. I would not have expected there to be any export restrictions on two coil springs for a bolt action rifle.

Here is what Wolff gunsprings has to say: https://www.gunsprings.com/index.php?page=International-Orders

They seem to say that anything under $100 is ok.

 

[michaeljp65]

Sorry to have wasted your time. I would not have expected there to be any export restrictions on two coil springs for a bolt action rifle.

Here is what Wolff gunsprings has to say: https://www.gunsprings.com/index.php?page=International-Orders

They seem to say that anything under $100 is ok.

No need to be sorry mate you only offered advice. All good. I had a look on the wolff site, they dont mention Stolle Panda action. Would you know if a remington ejection spring is the same or know of a similar match?

 

[A Marsh]

I don't know if the the Remington ejector spring is correct, but I do know that Wolff offers economical assortments of ejector springs. If you can measure the OD and wire diameter they should be able to tell you if that spring is in a kit. Worst you would have to do is trim it to length.

https://www.gunsprings.com/RIFLE AND SHOTGUN/Extractor & Ejector Spring Pak/cID4/mID134/dID406

I believe the Remington firing pin spring is correct for the Panda, but you will want to double check that.

 

[michaeljp65]

I don't know if the the Remington ejector spring is correct, but I do know that Wolff offers economical assortments of ejector springs. If you can measure the OD and wire diameter they should be able to tell you if that spring is in a kit. Worst you would have to do is trim it to length.

https://www.gunsprings.com/RIFLE AND SHOTGUN/Extractor & Ejector Spring Pak/cID4/mID134/dID406

I believe the Remington firing pin spring is correct for the Panda, but you will want to double check that.

Cheers mate, i did email Wolff with the spring measurements.

 

[1shot]

I don't know if the the Remington ejector spring is correct, but I do know that Wolff offers economical assortments of ejector springs. If you can measure the OD and wire diameter they should be able to tell you if that spring is in a kit. Worst you would have to do is trim it to length.

https://www.gunsprings.com/RIFLE AND SHOTGUN/Extractor & Ejector Spring Pak/cID4/mID134/dID406

I believe the Remington firing pin spring is correct for the Panda, but you will want to double check that.

You are correct. They are Remington springs.

Lloyd