Bat ejector pin help

[gambleone]

I'm trying to remove the roll pin so i can take the spring out. I used a 1/16" pin to try & drive it out but it won't budge. put a little kroil on it & let it set but will not budge. Any suggestions?

 

[gambleone]

Anyone?

 

[CoverDog]

Just worked on one last night. I always push from the pin hole closest to the ejector.

 

[gambleone]

Yes, did that. I used a Stanley pin punch & it bent. I ordered a better brand.

 

[Arthur]

Yes, did that. I used a Stanley pin punch & it bent. I ordered a better brand.

A Stanley 1/16 punch is bigger than it supposed to be it will not fit. Get a true size 1/16 roll pin punch.

 

[gambleone]

Arthur, thank you. I measured the pin, lo & behold, it was .072.
Guess that's why it don't drive out. It did cross my mind that it looked
a tad large, but says 1/16 in big black letters. Can't believe anything
anymore. Guess Stanley has a wider tolerance in it's dimensions than
the higher quality brands.

 

[Arthur]

I had the same thing happen with a Stanley punch as you did. Glad I could help you.

 

[gambleone]

Got it out thanks again Arthur