XP action stock specs?

[NorCalMikie]

Anybody know how the XP 100 action compares to other Remington actions?
Need a stock inletted for this action and wanting to know what other action cuts may be "close" as far as the inlet length.
40X? 600? 660? It'll be single shot and I'am looking for an inlet that is as close as possible. Any actual experience for this application? I've got the stock design i'am after without going the cu$tom route. Any input will be appreciated and thanks, Mike.

 

[Eddie Harren]

The XP-100 actions are roughly .500" shorter than a 700. The single shot XP's have no screw hole in the tang. The rear action screw is in the bottom of the action at the rear of the load/eject port. The rear tang is shaped differently than the 700. McMillan, Kelbly's, HS Precision and I'm sure other stock makers will inlet for the XP-100 when used for a rifle. Save yourself some time and do not try to make a M7 stock work. You may want to investigate an external bolt release also.

 

[NorCalMikie]

External bolt release is on my list.
The 700 might be an option. I already have a stock for the action but I'am wanting a BR style stock. Might end up fitting trigger guard or bottom metal if the inlet is close enough.
HS, Kelby's and Mc Millan would be in the high $$ range.
Laminated in the $200.00 range would be closer to what I want. I appreciate your input. ;D