Wilson seater die reaming 284 to Shehane

[Joe Wade]

I have a Wilson stainless steel micometer top bullet seating die in 284 Wichester.
I need a Sehane seater die. Can I ream the stainless steel with a High Speed 284Shehane finish reamer without ruining the reamer or do I need to get the Wilson chrome molly steel die blank?
I need Shehane seater die for arbor press and Wilson does not list one as an option.
Any help is appreciated, thanks.

 

[Dusty Stevens]

It will be just fine. They are not hardened. Just be aware of the headspace similarities. You may have to go .001 past then take that off the bottom of the die

 

[Joe Wade]

Thanks Dusty

 

[Paul Hilgedick]

I called Wilson about this same problem. They told me to run my reamer in it. No problem doing so.

 

[Joe Wade]

Thanks, Paul.