Wilson 6mm Dasher dies.

[AckleyImproved]

I am wanting input on Wislon Dasher dies, mainly in regards to stainless steel and micrometer top.

Now, I want to use the stainless, less hassle with rust etc, and want a micrometer top. I see Sinclairs make a micrometer top also.

So, the big question.

If I bought a Wilson stainless Steel micrometer bullet seater in 6mmBR, could I have the die reamed to 6mm Dasher? This way I get both stainless and micrometer all in one go. Is there any issues with the Wilson dies and seating long VLD bullets this way i.e I wont run out of adjustment on the die?

Thanks for your help!

Cheers
AI

 

[AckleyImproved]

gunamonth.. thanks mate....

I will go that way now for sure. Did you do the same thing with the Wilson stainless neck die?

Cheers
AI