What freebore for 6x47 for 105 Bergers

[missed]

I searched and searched.....

What is the ideal freebore for 6x47 for 105 bergers?

I am also planning on shooting the 70 grain blitz king also, but the primary important one is the 105 Berger.

I am thinking about a 26" 8" twist barrel as this will double duty target and varmints.

Thanks guys!

 

[alf]

What is the ideal freebore for 6x47 for 105 bergers?

.100"

 

[22DASHER]

What is the ideal freebore for 6x47 for 105 bergers?

.100"

.093"

;D

 

[jaygorski]

All depends, for Hybrids .104, VLDs, that .093 like someone mentioned.

 

[missed]

I was thinking about going with the hybrids. So it looks like the 104 freebore.

I am shooting the 185 hybrids in my 308.

I was thinking about going with the 105 hybrids for this build also. From yall's experience would you go vld or hybrid?

Thanks again!

I want to go no turn necks also, I have a 272 bushing for my Whidden bushing die ( bought used)

 

[alf]

I am thinking about a 26" 8" twist barrel as this will double duty target and varmints.

From yall's experience would you go vld or hybrid?

Hunting VLD's.

 

[HTSmith]

What Alf said. I could never get the hybrids to shoot quite as well as the hunting VLD's in my standard 6br w/ 8" twist. If you are going to shoot stuff that has hair then that would seal the deal in my mind.

 

[missed]

What bullet will load at 105 thou and still run through a short action AICS mag? Do any of yall have overall length on the bullets?

 

[Grimstod]

The 6x47L is a shorter case. Should not be an issue. If this was a 260 or 308 then OAL is a problem for longer bullets.

 

[missed]

The 6x47L is a shorter case. Should not be an issue. If this was a 260 or 308 then OAL is a problem for longer bullets.

Thanks! Bullets should be here this week. Just waiting on the barrel now.

I'm hoping it will shoot with the IMR4451 or 4350

 

[missed]

Does anybody have a no neck turn reamer print?

My barrel is supposed to be done with 105 thou freebore. I was going to load some and need a base to ogive measurement, but I can not seem to find a reamer print.

Thanks!

 

[alf]

I have this one:

http://cdn0.grizzly.com/specsheets/t10178_rp.pdf

The .272" is supposed to be a no turn, but it's still too tight for my liking. I did a skim cut, and I'm still over .270" on a loaded round. Plus, it's advertised as a .093" freebore, but is actually .100" by the print, vs what it could actually be.

I'm in the lands .015" or so, and my OAL is 2.680" w/ 105 VLD's.

Unless you have the same chamber, chambered by the same reamer, with the same lot of bullets, no one can give you an accurate measurement.

 

[missed]

Thanks! I'm right at 0.270 on a loaded round, I loaded a few at 2.758 coal. That put the base of the bullet at the base of the neck. Thanks for the link on the reamer, Google failed to find me one. I told the gunsmith 0.105 free bore.