TK Lee dot reticle question

[tominboise]

I have a Cooper in 20 VT. I'm shooting Hornady 32 gr vmax in it. I have a Nikon Monarch 6.5-20X with FCH reticle on it now. I want to send the scope to TK lee and have two dots put in it - A 1/2" dot at the center and a 1/4" dot 2 MOA below that. I'll sight in 1/2" high at 100 yards with the 1/2" dot, and use the lower dot when the range gets out there. The middle dot should range in size from 1/2",20X) to 1-1/2",6.5X) at 100 yards, and the lower dot should be 1",20X) at 400 yards and 3",6.5X) at 400 yards. The 2 moa spacing = 8" space at 400 yards.

Doeas anyone have a similar setup they are using? Or do you any comments on my proposal? And I think I have done the math correctly, please let me know if I haven't.

Thanks,
Tom

 

[Shooter32]

Im not sure if your math is correct, but if you call them at TK Lee and tell them the size that you want the dot at the power and yardage they can figure it out . Also tell them your bullet, caliber, how high the scope is, and velocity . And the yardage that you want your dots to be dead on at and they will get everything just right . :thumb: