tap size for hornaday comparator and drill bit size

[RW]

I need the size of the drill for the hornaday comparator case and tap size so I can make my own modified cases for ackley cases. and a supplier were i can get one if you have that to , Thank You Ron

I SEE WHERE THE ON THE DAILY BULLITON SO THAT WILL WORK THANKS ron

 

[jcampbellsmith]

http://bulletin.accurateshooter.com/2015/04/make-your-own-modified-case-for-hornady-o-a-l-gauge/ Regards JCS

 

[Ggmac]

I bought mine at Amazon

 

[rmist]

Lots of places to get it... MSC, McMaster Carr, Amazon, plus others like your better hardware stores.

 

[fguffey]

I use cases with good bullet hold, I drill the flash hole/primer pocket out to a diameter that accommodates a cleaning rod. After seating a bullet I chamber the case and then push the bullet out until it contacts the rifling.

F. Guffey

 

[Nvreloader]

RW

The tap size is 5/16 x 36 tpi.

Tia,
Don