TAC for .308 gas gun?

[Flycaster1977]

I recently picked up a ruger sfar in .308. I have a pile of tac and bullets from 130-180 grain. Just wondering what your experience is with this combo.

 

[ggshoots]

I have used TAC in 308 and believe I have shot it in my SFAR. Will have to look back at some targets and see if I have any. I know I was trying to find a load with 150's.

 

[6Creed73]

I use TAC in .308. It's a great powder and can be used for 5.56/223 as well.

 

[ggshoots]

I was looking, my Tac loads I kept targets on were for bolt gun. It shot very well. I also loaded 150's for my SFAR but shot them at steel so no targets kept.

 

[Flycaster1977]

Thanks

 

[searcher]

I had pretty good results using 44 grains with 150 grain bullets in my M1-A, though Reloader 15 was superior in my rifle. N140 and IMR 4064 were good too.

 

[DiffEQ]

I use TAC but prefer to use it with the lighter bullets, 125, 147 & 150gr.
I love it in 223 because of its metering.

 

[D the D]

TAC works in my FAL to fake M80 siblings. N140 for serious loads in the M1a. TAC is also my numero uno for 223 generic loading, like plinkers for kids/nephews/nieces. Uncle D is the go to guy to for plinking ammo. There again, N140 is for my DCM/NRA Highpower rifle.

 

[Flycaster1977]

I had pretty good results using 44 grains with 150 grain bullets in my M1-A, though Reloader 15 was superior in my rifle. N140 and IMR 4064 were good too.

Reloader 15 has been superior for me in every .308 based cartridge i have loaded. However, i have a pile of tac, and not so much rl15.

 

[Flycaster1977]

i loaded some test loads with tac and 150 grn nosler bt, because i also have a pile of these. Im just using this as a fun thing. I’ll try some 165’s too.