Michael Mattone
Silver $$ Contributor
Threading dial in nice shape as well as the micro stop. I disassemble both cleaned, lubed and painted them. They definitely fit my lathe. I'm not sure what others they might fit. Micro stop has around 1/2 inch of overall travel with minimal lash. Guys have a bad habit of over tightening these and cracking the casting as was this one. It has been repaired properly and fits very well on to the ways. It is very strong repair. Just don't take a 12 inch crescent to it! These were both extras when I purchased my lathe. I would like $50.00 each plus shipping. I can combine if you take both. I'll reply to any questions. Thanks Michael 
