Sizing well in advance of loading

[dboyles]

and there may be more to it than diameter shows

Yeah, that's what I was getting at. For my purposes, I think I'm fine to do either/or as long as I do the same thing for each batch of ammo. I'm familiar with the lengthy discussions that go on about ammo loaded well in advance of shooting and about changes in brass over time, but was curious if there were any concerns about that which is simply sized in advance of loading.

Here's the part where I say thanks for everybody's input, but if anybody has anything else to add, I'm all ears...

 

[tenring]

I have saved this since it appeared in The Bulletin 8/28/08:

This may surprise you. We’ve learned that time (between neck-sizing operation and bullet seating) can have dramatic effects on neck tension. Controlling neck tension on your cases is a very, very important element of precision reloading. When neck tension is very uniform across all your brass, you’ll see dramatic improvements in ES and SD, and your groups will shrink. Typically you’ll also see fewer fliers. Right now, most reloaders attempt to control neck tension by using different sized neck bushings. This does, indeed, affect how firmly the neck grips your bullets. But time of loading is another key variable.
James Phillips discovered that time is a critical factor in neck tension. James loaded two sets of 22 Dasher brass. Each had been sized with the SAME bushing, however the first group was sized two weeks before loading, whereas the second group was neck-sized just the day before. James noticed immediately that the bullet seating effort was not the same for both sets of cases — not even close.
Using a K&M Arbor press equipped with the optional Bullet-Seating Force Gauge, James determined that over twice as much force was required to seat the bullets which had been neck-sized two weeks before. The dial read-out of seating force for the “older” cases was in the 60s, while the seating force for the recently-neck-sized cases was in the 20s. (These numbers correspond to pounds of force applied to the bullet). Conclusion? In the two weeks that had elapsed since neck-sizing, the necks continued to get tighter and stiffen.
Lesson learned: For match rounds, size ALL your cases at the same time. If you want to reduce neck tension, load immediately after sizing.

 

[K22]

I dont see any reason not to size and prepare them in advance.I have done it for years and when I go through all of them,I start over and prep again.

Same here - never experienced any problems with sizing well in advance (sometimes 12 to 18 months) of loading and shooting.