Sinclair vs. Holland Brass Monkey

[ericskennard]

Does any one have any experience with either the Sinclair Power Center case turner or the Holland Brass Monkey?

I thought I would look for some feedback before purchasing as they are both expensive. I am neck turning a larger quantity of brass and was looking for a faster way!
Eric

 

[Rootshot]

Try a drill with a 1/2' chuck. You can chuck cases directly into the drill.

I have a sequence that works very rapidly.
1. Chuck a case hand tight.
2. Trim using Possum Hollow Quik Case trimmer.
3. Deburr flash hole with RCBS debur tool,index off trimmed case length)
4. Dip case necks into Imperial sizing wax and turn neck on K&M Turner.
5. Chamfer inside of neck using Holland carbide tool.
6. Deburr outside of neck.
7. Pop out of drill.

If you lay your tools out, this will only take a few moments per case.

--Rootshot

 

[Winchester69]

Neck turning?

www.matchprep.com/shaver.htm
.

 

[Hammer]

Have two Sinclairs.

Work fine.

.