• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Shotmarker target ?

9146gt

Gold $$ Contributor
I have a source to print F class MR-63C 300 yard targets on coroplast. Where do we get the graphics file for those targets?
Tom
 
I print mine on 8 1/2 x 11 paper. Top and bottom or cut off, but elevation is not an issue.
I have done the same thing with the 500 yard target on 11 x 17 paper
 
I can make it that way i think. When I draw it, it's not to any given scale per say. When I send it to the layout page, that's when I scale it. I have to pic paper size at that time. I don't know what the "proper" paper size is supposed to be for the targets I make. I'll look in the NRA rule book i downloaded and see if it is in there.
Can you tell me the proper width of the white ring around each scoring ring. I think the 10 ring on the MR-63C 300 yard target is 2.9" that makes the inside of the white ring 2.9". I think I have the white at .125 width which looks too wide.
 
I did not have calipers large enough at the house so measurements are in fractions.
paper is 20"x 20"
white line is .050" wide
X ring is 1 3/8"
10 ring is 2 13/16"
9 ring is 5 13/16"
8 ring is 8 13/16"
7 ring is 11 13/16"
6 ring is 17 13/16

Thanks
Tom
 
Ok. My suspicions were confirmed. 20 x 20 paper is not recognized in my architectural drawing program.
On a whim, I created it on a 22 x 34 paper size at a 1 to 1 scale. I'm hoping your printing folks can center the image on the 20 x 20 format and print to scale. If so you're good to go. Or I can provide the drawing in a DXF or DWG format if that helps.
Let me know how I might help.
David
 

Attachments

While we are on the subject. How about a source for printable 600 yard centers? letter or legal size paper.

Edit: I shot a match Saturday, where the repair centers were printed on sticky paper. Peel and stick the center on and done.
 
Ok. My suspicions were confirmed. 20 x 20 paper is not recognized in my architectural drawing program.
On a whim, I created it on a 22 x 34 paper size at a 1 to 1 scale. I'm hoping your printing folks can center the image on the 20 x 20 format and print to scale. If so you're good to go. Or I can provide the drawing in a DXF or DWG format if that helps.
Let me know how I might help.
David
I will check to see if they can print that. Thanks for all the help.
Tom
 
So far, I have not bothered to print off a "target" I just use a 3 inch yellow aiming mark that is centred on my frame. The Target shows on the iPad. Works fine out to 500, which is all I use for ammo testing.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,355
Messages
2,216,958
Members
79,565
Latest member
kwcabin3
Back
Top