Seek source for thicker Front Rest Feet

[tangocharlie]

A few years back I bought a couple of (then) SuperFeet that were thicker than normal - approximately an inch. Does someone still make these? I have looked…

 

[6ShotsOr5?]

About 2 years ago I bought some from the vocational program over in PA where the kids make shooting rests and the proceeds go back into their program. I can’t remember the contact info but somebody on here will remember.

 

[JoeMcNeill]

Cowen rests in PA.

JDM

 

[6ShotsOr5?]

But I think it’s spelled Cowan

 

[6ShotsOr5?]

Contact Joseph Cowan @ cowanhaus@gmail.com, might take a few days but he will get back to you.

 

[prwhite]

My three Cowan feet that I purchased a number of years ago we’re about 1” thick and weighed about 2# each.

 

[big_bad_22]

A bit unconventional but a hockey puck is 1 inch.

 

[Bill Norris]

These are the ones I purchased about a year ago from https://www.mcmaster.com/ 1/2 x 13 x 4 3 each 6111K33 Stud 11.21 each 33.63 The knob at the top is separate 1/2 x 13 x 3 each 6399K55 Knob 13.44 each 40.32

 

[jpx2rk]

These are the ones I purchased about a year ago from https://www.mcmaster.com/ 1/2 x 13 x 4 3 each 6111K33 Stud 11.21 each 33.63 The knob at the top is separate 1/2 x 13 x 3 each 6399K55 Knob 13.44 each 40.32

Did the studs screw into the existing holes or did you have to alter them to fit???

 

[Bill Norris]

Oh no they fit in the hole with no issues at all. It is a 1/2 X 13 thread hole.

 

[Mulligan]

High-Quality Shooting Accessories from Joe Cowan « Daily Bulletin

Machinist Joe Cowan of Altoona, PA offers some nicely-designed products for F-Class and Benchrest shooters. These products would also be useful for Varminters who use pedestal rests.

bulletin.accurateshooter.com

CW