savage action screws

[50bmg1979]

Can someone tell me what size the Savage model 12 target action screw size is? I got a new savage rblp 4.4 action and it didn't come with action screws. Thanks

 

[Highpower-FClass]

Thread pitch is 1/4X28. I've never had any luck finding these in hardware stores, I've bought them from Boyds, they're available at other online stores as well (Midway, Brownells).

https://www.boydsgunstocks.com/Prod...e-10110-front-and-rear-action-screw-set-blued

 

[ttfreestyle]

My ace hardware has them in the specialty screw drawers. Good luck

 

[mattri]

What length do you need, I have a few extra. could send you a couple no charge.

 

[Steve Ladino]

What length do you need, I have a few extra. could send you a couple no charge.

Good for you man !

 

[Big Mc]

Can someone tell me what size the Savage model 12 target action screw size is? I got a new savage rblp 4.4 action and it didn't come with action screws. Thanks

Ace has them..

 

[Blackthorn]

Screw length is:
front and screws are 1-1/6"
The back screw is 1-1/2".

 

[NorCalMikie]

You can pick them up at just about any big hardware store. 1/4" X 28. Get them long and cut them to the length YOU WANT!! Most factory screws are on the shorter side so if you get them a bit longer, you can cut them down and have full action thread contact.

 

[dickn52]

Can someone tell me what size the Savage model 12 target action screw size is? I got a new savage rblp 4.4 action and it didn't come with action screws. Thanks

Call Savage. I put a BR stock on mine and forgot to get the correct length screws. They mailed the next day.

 

[50bmg1979]

What length do you need, I have a few extra. could send you a couple no charge.

Pm sent. Thanks

 

[50bmg1979]

I want to thank everyone for your replies and to Mattri especially. This forum is great!

 

[Iowa Fox]

The screws get match'd to the stock. Before you put your barrel on torque the action into the stock. You want 99.5 % thread engagement so you don't strip the holes in the action and not too long to protrude into the action for the bolt to catch on. After you have it torqued up nice make sure the bolt opens & closes and slides freely. Then check to make sure the bolt catch will release the bolt.

 

[GaryL1959]

Can someone tell me what size the Savage model 12 target action screw size is? I got a new savage rblp 4.4 action and it didn't come with action screws. Thanks

I use 1/4-28tpi, 12 point, grade 9 bolts from McMaster-Carr. Takes a 12 point 1/4 inch socket (perfect for torque settings) and are a lot more resistant to stripped threads than the factory screws. These have to be cut to length, I use a cut-off wheel in a Dremel. I have plenty of extra's, is anyone wants to try them, pm me a mailing address and i'll send a set.