Hello Everyone, have a little project ongoing and need some advice on the setup. To begin, I took a Model 116 SS action off a new rifle, previous caliber was a 270 WSM. Original stock was the weather warrior series I believe, that cheap plastic one and it was DBM. Anyways, I am setting this action up on a blind magazine custom wood stock and bought a loading ramp from Sharp Shooter Supply in hope that I can convert it to a center feed for this stock and action setup. I know the loading ramp designed by sharp shooter was originally designed to convert to a single shot but would like to make it a repeater. Can I epoxy a spring to bottom of loading ramp to make this happen, or am I straying off too deep and setting myself up for failure. Any advice is appreciated, thanks guys for any input.