Ring Height and Suggestions

[cmh259]

So I pulled the trigger and bought the Sightron 10-50x60 LR for my Savage F Class in 6.5x284 and am looking for suggestions on rings. It already has a 20 moa picatinny rail rail on it so looking for suggestions on height and brands you may have used with this setup. Thanks in advance!

 

[Kracken McGraw]

https://www.midwayusa.com/product/1086981288401?pid=896813I have used the Seekins Precision 1.26 extra high rings on a couple of rifles with a 20 moa rail. In the link above, Midway measures them differently and says .67 height but they are the same rings.

 

[RabbitSlayer]

I agree with seekins extra high. I have their high rings with 20moa rail on a couple with 50mm, and that is good with a heavy barrel. Check amazon amd midway Sometimes they have blems or a certain height is cheaper. Just got medium-high off Amazon for less than anywhere else.

 

[cmh259]

https://www.midwayusa.com/product/1086981288401?pid=896813I have used the Seekins Precision 1.26 extra high rings on a couple of rifles with a 20 moa rail. In the link above, Midway measures them differently and says .67 height but they are the same rings.

Pics?

 

[cmh259]

I agree with seekins extra high. I have their high rings with 20moa rail on a couple with 50mm, and that is good with a heavy barrel. Check amazon amd midway Sometimes they have blems or a certain height is cheaper. Just got medium-high off Amazon for less than anywhere else.

Pics?

 

[RabbitSlayer]

Pics?

Tikka, 20moa egw rail, seekins high, heavy varmint barrel, tract toric 4-20x50. It is just about right to me. It can't really go lower cuz the big power ring.

 

[bobby1028]

Level the rifle on a bench and stack washers on the rail where the rings sit until you can hold the tube on top and clear barrel and magnification ring, measure the stack of washers and add half the diameter of the scope tube...you now have absolute minimum height required.

 

[Kracken McGraw]

Level the rifle on a bench and stack washers on the rail where the rings sit until you can hold the tube on top and clear barrel and magnification ring, measure the stack of washers and add half the diameter of the scope tube...you now have absolute minimum height required.

Coins may be easier to find for some.

 

[bobby1028]

Forgot to mention measure with the sun shade installed, especially if you're running a canted base...