Rem. 700 Trigger Tech Primary Trigger question

[p5200]

I just installed one in a bergara bmr 22lr. Anyone know if the adjust screw will pop out if turned to far down? I've had experiences with springs flying across the room. I know the factory screw will come all the way out. I turned it out quite a bit and decided to stop lol! Thanks!

 

[B y r o n]

"NOTE: Always keep the set screw engaged with at least three “Clicks” to prevent the set screw from falling out."

Instructions

 

[jepp2]

I know the factory screw will come all the way out. I turned it out quite a bit and decided to stop lol!

Can't answer for the TT, but on the factory trigger, the spring is captive so even if the screw falls out, you will not lose the spring. And the trigger continues to function normally. Don't ask me how I know....

 

[p5200]

I took screw out of the factory trigger also. The trigger -Tech feels less than 1 lb pull and I stopped turning the screw all the way. I had to dremel the ends of the trigger pins. They stuck out to far for the safety lever. One pin was hanging up in the stock.