Redding die question

[CaptBeach]

I ordered this die set... http://www.midwayusa.com/product/172408/redding-2-die-set-243-winchester-ackley-improved-40-degree-shoulder...

then I notice it has a crimp ring...is this going to screw up my reloading...I do not want a crimp... discuss...

 

[Joe O]

Seems all or most seating dies have roll crimp rings,even 45ACP.Just back off the die when adjusting with ram up case inserted.You could load with hunting bullets that have a crimp grove.Or use a different seater.I use a Vickerman for all rifle seating.

 

[jcampbellsmith]

From the Redding instructions - BULLET SEATING

Redding bullet seating dies have a crimping ring that can be used to apply a roll crimp to
the case mouth when using bullets that have a cannelure or crimping groove. (Do not
attempt to roll crimp bullets without a cannelure or crimping groove. Damage to the case
may occur.) With the ram in its uppermost position, screw the bullet seating die into your
press until it touches the shellholder. If no crimp is desired, back the seating die one turn
away from the shellholder. Tighten the die body lock ring and adjust bullet seating depth
with the seat plug. To seat and crimp bullets in one operation, adjust the die for no crimp
as described above and seat bullets so the case mouth is at the top of the cannelure or
crimping groove. Then back the seat plug away from the bullet at least two turns and
screw the die body into your reloading press in small increments until the case mouth is
rolled into the cannelure or crimping groove. Deformed or bulged case mouths are an
indication of too much crimp. Tighten the die body lock ring and adjust the seat plug so
it firmly contacts the bullet, and tighten its lock ring. Your die is now adjusted to seat and
crimp bullets in the same operation.
Good luck. JCS