• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

RCBS Bullet Mold Issue

I am stumped . I have never run into this issue before . I have an RCBS bullet mold & can not get the handles off of the mold body . I have not used it for quite a while . It is a .416 350 grain for casting bullets for my 416 Barnes lever gun . My 76 year old brain does not remember how I attached the handles . I removed the Allen head set screws & noticed there are posts running upward from the handles . They will not depress so I can separate the mold from the handles . Enlighten & refresh my mind block on how to remove these handles so I do not damage the mold body . Thanks .
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
165,407
Messages
2,194,637
Members
78,873
Latest member
jimi123
Back
Top