Quickload Request 7x64

[Scrumbag]

Hi folks,

Would anyone be willing to run Quickload on the 7x64 for me?

84mm OAL
Fully resized brass
26" barrel
160gr TMK

Everything else CIP / SAAMI defaults

Any data I use will be at my own risk.

Any help much appreciated.

Scrummy

 

[Kurz]

Well, if at first you don't succeed, here is the alternative:

The first 7x64 I shot, I used some Norma factory which was extremely accurate in that rifle:

https://www.norma-ammunition.com/en...pstrike/norma-tipstrike-7x64-160gr---20171152

The .280 Remington is very similar to the 7x64 Brenneke:

https://load-data.nosler.com/load-data/280-remington/

https://www.ballisticstudies.com/Knowledgebase/7x64+Brenneke.html

Following the trend of success using the factory ammunition, I found some MRP powder and the Nosler 160 grain Accubonds. I think the 160 TMKs are very similar but some simple testing should get you to a point of satisfaction. Your chamber will determine which bullets are suitable.

More data and bullets to choose from:

https://revivaler.com/the-7x64-brenneke/

Enjoy the process!

 

[Ares]

Pretty much use 280 rem load data, start a little low and work up.
The case capacity difference is mere 1 grain in favor of the 7x64.
The listed max pressures are higher too according to cip.
You will find a lot less data on it in the US then in Europe, where it is more popular then the 280.

 

[Scrumbag]

Thanks folks, just not seeing much on the TMK and I'm working on a target load