• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

PTG Bolt

Has anyone used a PTG one piece bolt for a REM 700,
how did you finish it?

my action is stainless and the bolt looks like stainless but
I know its not. How should I finish it so it wont rust,
I have had some spots already. I don't want to coat it
with oil and have it collect everything that's floating around
to attach to it.

Thanks for any responses
 
Have you test fired the gun yet? The first and last PTG bolt I used needed to have the nose sleeved because it was machined .015 off center. I didn't find out until after it had come back from DLC coating.
 
Have you test fired the gun yet? The first and last PTG bolt I used needed to have the nose sleeved because it was machined .015 off center. I didn't find out until after it had come back from DLC coating.


Yes I have shot it.

I had issues with the bolt similar to yours, mine wasn't concentric. had to turn it down.
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,303
Messages
2,216,203
Members
79,551
Latest member
PROJO GM
Back
Top