PR&T stock work

[Caleb85]

When finishing the inlay on these, would a standard mill bit work? Say a 4 flute? Or would it splinter too much? Should a router bit be used? This is for the ejection port cut out and bolt handle cut out. Thanks

 

[Cigarcop]

I use a 2 flute straight and ball nose. Sharp and fast..... I just finished bedding and milling this one out.

 

[Caleb85]

Thank you

 

[butchlambert]

On a round receiver I use a carbide tipped corebox router bit.

 

[boltfluter]

I use a 2 flute straight and ball nose. Sharp and fast..... I just finished bedding and milling this one out.

Cigarcop,

Some of the best bedding work that I have ever seen. Congrats on a fantastic job.

Regards, Paul

www.boltfluting.com

 

[hpshooter]

I just finished bedding and milling this one out.

That is a very nice piece of work! Thanks for sharing the pictures.