Needed: Machinist to add/pin muzzle Brake TC

[snert]

I have a factory 14 inch TC Contender 22 K-Hornet barrel. I need someone who can make/add about 4 inches (stainless) muzzle brake to it and pin it so I can make "carbine length" . Anyone interested in a project? PM me if you have interest.

 

[AckleymanII]

All you need is a "bloop tube" that is permanently affixed to add length, pass the JB weld!

thread existing barrel, bloop tube threaded internally, done!

 

[akajun]

All you need is a "bloop tube" that is permanently affixed to add length, pass the JB weld!

thread existing barrel, bloop tube threaded internally, done!

Glue doesn’t cut it with the atf
It needs to be blind pinned or silver brazed.

 

[Dusty Stevens]

Glue doesn’t cut it with the atf
It needs to be blind pinned or silver brazed.

They told me if they couldnt remove it with a couple pipe wrenches thats about right. I dont think jb weld or loctite will hold up to a pipe wrench

 

[snert]

I am aware it needs be pinned...just looking for someone who would do it for me. "id settle for just getting it made, I will worry about the permanent part if that is the deal breaker.

 

[joshb]

You shoulda oughta send skeetlee a pm. He did a barrel for me, fast.
You could also call Bob Green in York, Pa. He does all my work. Great guy and a fine gunsmith.

 

[carlsbad]

I've done this job before. How heavy is your barrel?

 

[snert]

PM to Carlesbad...