I just bought one of these but I haven't done any neck turning with it yet.
I was just going to use it for my first neck trim and then make my second cut with my pumpkin.
Will these do the job I am looking for? Like I said, I haven't used it yet by things don't look perfectly horizontal.
With the pumkin the shaft just fits in the neck and then you cut around the outside to get it down to tolerance for my 6.5 284.
but...
the rcbs tool seems a little off, and it looks like it will have a high and low side
I just wondered it anyone had had any experience with one.
I also notice that it will turn the inside as well as the outside, which I haven't done before. Before I just used an expander mandrel and the pumpkin.
thx
I was just going to use it for my first neck trim and then make my second cut with my pumpkin.
Will these do the job I am looking for? Like I said, I haven't used it yet by things don't look perfectly horizontal.
With the pumkin the shaft just fits in the neck and then you cut around the outside to get it down to tolerance for my 6.5 284.
but...
the rcbs tool seems a little off, and it looks like it will have a high and low side
I just wondered it anyone had had any experience with one.
I also notice that it will turn the inside as well as the outside, which I haven't done before. Before I just used an expander mandrel and the pumpkin.
thx
