• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Neck turning the shoulder

Before I turn the necks of a bunch of new Norma 284 win brass, I have a question of just how far down do you turn into the shoulder? I'm using a 21st Century turner 35 deg cutter. I've got the thickeness set for .0055" clearance for the .318" neck chamber. Here are 2 test turned necks. Do either of these (left and center) have the correct depth for the shoulder turn? Thanks.
 

Attachments

  • DSC_0169.JPG
    DSC_0169.JPG
    170.6 KB · Views: 413
Last edited:
Hi Frank, The center pik is the good one. Slow down on the feed-rate.
Feed in and out at the same feed-rate.The carbide cutter i grind is designed to cut in both directions ..Thanks, John
 
Somewhere in between those two cuts would be ideal!
 
I turn until I can just begin to detect a ridge with my fingernail. When in doubt, sacrifice a case and section it with a dremel tool so you can visually see how much wall thickness remains.
 
Thanks John for the advice. Much appreciated. Trying to get the hang of your cutter. Have been using a Forster on 270 win brass. But your turner is a WAY better tool.

Thanks fellas.
 
Last edited:
I just touch the leading edge of the shoulder. I turn on a lathe, the tip of the bit honed to a slight radius instead of a sharp point. It makes for a better finsih and rounded transition instead of a sharp step.

33jkzur.jpg


Bill
 
FWIW, my philosophy on neck turning is to 1st determine whether there is a probability of having any sort of donut problem at the neck/shoulder junction. If there is no known problem in that area with your particular brass, then a cut just touching the shoulder should be fine. However, if your brass is known to want to produce a donut, or tight internal spot, at the neck/shoulder junction I cut into the shoulder in order to thin that area a little. After FF there should be no future problem no matter how deep you have to seat the bullet. This will probably take a little experimentation to determine optimum turning procedure. Hope this helps a little. Joe
 
  • Like
Reactions: JRS
I turned some ppc necks a few weeks ago, and cut just a tad too far into the shoulder. When I sized them, some of the necks tore off and remained stuck in my bushing. Got em out, but not fun. The donut should not be a problem if base of your bullet does not touch it. Err on the side of too little a cut into the shoulder.
 
I like the middle example, but since the 284 Win has a 35-deg shoulder (which matches your cutter) the case on the left hasn't really been cut as deeply as it might appear.
-
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,829
Messages
2,223,895
Members
79,899
Latest member
Orville. Johnson
Back
Top