I picked up the K&M neck tool and of course the correct mandrels. This is all Lapua blue box brass.
I can actually see the difference in the quality of my sizing dies (Even after using my 21st century neck expander). I have the benchrest Forster sizing die for my 6br I had custom honed. When I neck turned my brass all it took was a skim cut to have shiny brass and no low spots.
My 6.5CM and .223 again Lapua brass I have been using RCBS sizing dies and the correct degree cuter I can see low spots. I stopped after two and ordered a ball mic AND bought a couple of forster bench die sets.
I can actually see the difference in the quality of my sizing dies (Even after using my 21st century neck expander). I have the benchrest Forster sizing die for my 6br I had custom honed. When I neck turned my brass all it took was a skim cut to have shiny brass and no low spots.
My 6.5CM and .223 again Lapua brass I have been using RCBS sizing dies and the correct degree cuter I can see low spots. I stopped after two and ordered a ball mic AND bought a couple of forster bench die sets.
