MTM case for 30BR?

[TommyD11730]

Hey Guys
Does MTM make a 50 count case for 30BR that's short enough to grab the brass only?

My RM-50 the cases are too tall to grab the cases.

Thanks!

 

[Bill Norris]

Hey Guys
Does MTM make a 50 count case for 30BR that's short enough to grab the brass only?

My RM-50 the cases are too tall to grab the cases.

Thanks!

If so I have not seen it. I normally turn the case head up to be able to get a finger nail under the rim.

 

[Fast14riot]

RSS 50 is shorter and what i use for 6br.

 

[Bill Norris]

RSS 50 is shorter and what i use for 6br.

View attachment 1633830

Same one I use.

 

[TommyD11730]

Thanks guys, I'll give the shorter cases a try.

 

[Trigger-Jerker]

As others have stated the RSS-50 works or you can buy a bag of 10mm wooden craft blocks off Amazon and put one in each hole to take up the space.

 

[Gabe22BR]

Use pluck/ pull foam 1/2”x1/2” stick in bottom to elevate case

 

[Fast14riot]

Now if they would make an RSS 100 I would be really happy.

 

[joshb]

RSS 50 is shorter and what i use for 6br.

View attachment 1633830

Thanks for that! I just ordered 12. I’m sure they’ll work for 45 Colt and 44 magnum, too.

 

[JMayo]

This is what i use. Sits well beside my seb

 

[Kracken McGraw]

https://www.midwayusa.com/product/1564136346?pid=912531
I think these would work if you like the better latch and handle with more space between cartridges.
I use this type in 100 rounds for the 6BR.
You need to buy and cut their foam to put in the lid.

 

[Fast14riot]

https://www.midwayusa.com/product/1564136346?pid=912531
I think these would work if you like the better latch and handle with more space between cartridges.
I use this type in 100 rounds for the 6BR.
You need to buy and cut their foam to put in the lid.

Dang, from 6br to 30-06 cases listed for that one. I may just head over to Bass Pro with some brass and dummy rounds to check them out.

 

[Andy Work]

I don't know if they have one for the BRs, but the Cabela's branded 222/223 boxes are much better than the MTMs as far as usability. The empty cases are much easier to grab in the Cabela's.

 

[Fire Dog]

I don't know if they have one for the BRs, but the Cabela's branded 222/223 boxes are much better than the MTMs as far as usability. The empty cases are much easier to grab in the Cabela's.

View attachment 1635150

The box with a “proper” hinge is the better box always as sooner or later those thin “flex” hinges will fail. They also tend to try and close the lid rather than being able to fully open the lid out flat.
Peterson 6BR brass comes in a great box {much better than Lapua flexi hinge and the loose insert if you decide to use the box for loaded ammo} I have used the boxes and brass for years, neither have failed in over 5 years… {:~)

 

[Andy Work]

The box with a “proper” hinge is the better box always as sooner or later those thin “flex” hinges will fail.

They both have the good hinges. The problem with the MTM is that the empty cases sit too low in the box making them hard to remove. I have some of the old flex hinge cases that try to close on their own.