Magpul 700 Pro 700 SA chassis in FDE

[m1k3]

Only used for one year from a bench.

Has both position grips, original box, well taken care of. Relieved the corner for the recoil lug to give a little clearance for Bighorn action. I 3d-printed a bag rider for the rear lower stock. That's included.
$600 shipped from Texas.

 

[m1k3]

TTT

 

[Dax.Fulbright]

Only used for one year from a bench.

Has both position grips, original box, well taken care of. Relieved the corner for the recoil lug to give a little clearance for Bighorn action. I 3d-printed a bag rider for the rear lower stock. That's included.
$600 shipped from Texas.

View attachment 1714562View attachment 1714563View attachment 1714564View attachment 1714565

Has this sold yet? Were are you located in texas?

 

[m1k3]

Still got it. San Angelo, TX.

 

[Dax.Fulbright]

Still got it. San Angelo, TX.

Still got it. San Angelo, TX.

Can i get a closer picture of the radius of the recoil lug area?

 

[m1k3]

Can i get a closer picture of the radius of the recoil lug area?

Just knocked the sharp corner down with a Dremel. My big horn action with the integral lug has a slight radius there and would rock on that edge.

 

[DLT]

View attachment 1720252

Just knocked the sharp corner down with a Dremel. My big horn action with the integral lug has a slight radius there and would rock on that edge.

Not hurt in the least

 

[m1k3]

Yeah, it's minor and has that same edge rounded on other chassis brands. On my Manners mini chassis and on my foundation stock are both already rounded or beveled there.

 

[papa]

I'll take this stock.
Tim

 

[m1k3]

SPF