Magnetospeed Unplugged Bayonet Error

[USAFRet]

So, I was at the range today. Al things going well and good. Set my rifle to the side for the barrel to cool, pick it back up and get an error that the bayonet is unplugged, when it was plugged in and working fine 10 min before. Anyone run into this?

 

[USAFRet]

 

[itchyTF]

Bad connection? Remove and re-plug.

 

[jelenko]

From a google search, people are reporting they had to contact customer service. Apparently something can be loose even with the plug properly seated.

 

[piie]

The barrel jack connector on the PCB is most likely loose. If you know a bit of electronics, and/or can solder/reflow, you might be able to fix yourself - that's obviously if the unit is out of warranty. Most electronic repair shops would also be able to fix / replace the barrel jack/connector - the jack is available on Amazon, I fixed my own one - if you need details about the exact type of jack/barrel, PM me.