Machine forming and inletting a Good blank.

[butchlambert]

You don't need no duplicator, just ba hammer and Chisel. Follow this thread on my 22RF stock by Evan Koch.

http://www.rimfirecentral.com/forums/showthread.php?t=580905


By the way, Duane Wiebe is one of the very top stockmakers and gunsmiths in the USA if not the World. Check his duplicator.

http://forums.accuratereloading.com/eve/forums/a/tpc/f/7971019521/m/2591018751?r=4401029751#4401029751

 

[Eddie Harren]

Butch, I've seen several duplicators like Duane's. Made by a company called "Armstrong".

 

[shortgrass]

You don't need no duplicator, just ba hammer and Chisel. Follow this thread on my 22RF stock by Evan Koch.

http://www.rimfirecentral.com/forums/showthread.php?t=580905


By the way, Duane Wiebe is one of the very top stockmakers and gunsmiths in the USA if not the World. Check his duplicator.

http://forums.accuratereloading.com/eve/forums/a/tpc/f/7971019521/m/2591018751?r=4401029751#4401029751

Did I not say "$450 is too much"? When I went to school we were required to make our stocks by hand from a blank. I've made 11 in that manner, so I really don't need to waste any more time than I do now on these internt forums. I usually work from a pre-inlet, now. Did you bother to send that stock back or at least call and discuss your concerns? The one he did for me was much more refined on the outside and the inletting was straight and I wasn't 'cheated' on forearm or butt stock length, it was well centered in the blank. I'm well aware of Mr. Wiebes' work and reputation. And I've seen several diffrent makes of duplicators, I just don't happen to own one.

 

[butchlambert]

You don't need no duplicator, just ba hammer and Chisel. Follow this thread on my 22RF stock by Evan Koch.

http://www.rimfirecentral.com/forums/showthread.php?t=580905


By the way, Duane Wiebe is one of the very top stockmakers and gunsmiths in the USA if not the World. Check his duplicator.

http://forums.accuratereloading.com/eve/forums/a/tpc/f/7971019521/m/2591018751?r=4401029751#4401029751

Did I not say "$450 is too much"? When I went to school we were required to make our stocks by hand from a blank. I've made 11 in that manner, so I really don't need to waste any more time than I do now on these internt forums. I usually work from a pre-inlet, now. Did you bother to send that stock back or at least call and discuss your concerns? The one he did for me was much more refined on the outside and the inletting was straight and I wasn't 'cheated' on forearm or butt stock length, it was well centered in the blank. I'm well aware of Mr. Wiebes' work and reputation. And I've seen several diffrent makes of duplicators, I just don't happen to own one.

Shortgrass, I really think that you are a good guy and have thought that since you appeared on the forum. I stated my opinion and I respect yours. I will not post anymore on this thread.

 

[deadwooddick]

Jesse Kaufman.

http://www.blackhillsgunstocksandengraving.com/