Lightweight barrel blocks?

[robbor]

Is anyone still making barrel blocks?
Ther used to be a lightweight side clap one someone made. But I don't recall who. I always waned to try one. Thinking of blocking my savage 300 rum and getting a new barrel

 

[357Mag]

Is anyone still making barrel blocks?
Ther used to be a lightweight side clap one someone made. But I don't recall who. I always waned to try one. Thinking of blocking my savage 300 rum and getting a new barrel

Robbor -

Here's what I did...

Re-locatable barrel clamp:
Doubled-up " plumbing clamp " plates, 1/4-20 Carriage bolts w/ head relief cuts one side,
torque plates co-opted from "U"-bolts", 1/4-20 Nylon insert lock nuts; 24in lb torque.

Aluminum " H " beam w/ cuts made for trigger clearance slot, a slot for recoil lug; relief cut for bolt handle. 5/4 composite deck board bore end... butt stock...and removable cheek piece. Galvanized conduit hangar hand-formed into 90* trigger guard.

Floated action. Move clamp to tune out undesired vertical.

Chambered in my wildcat " DEEP 6 ".

Scope not pictured

With regards,
357Mag

 

[357Mag]

Is anyone still making barrel blocks?
Ther used to be a lightweight side clap one someone made. But I don't recall who. I always waned to try one. Thinking of blocking my savage 300 rum and getting a new barrel

Robbor -

Howdy !

You lovers of fine rifle craftsmanship... turn away, and protect the innocence of your eyes !


With regards,
357Mag

 

[Lee in Texas]

Robbor -…

Chambered in my wildcat " DEEP 6 ".

Scope not pictured

With regards,
357Mag

What is a Deep 6?