not sure if i used correct terminology, but just curious. my print of reamer has some numbers that may be this measurement. pt&g print...just below bore dia number and just to left of the 1degree 30min slope is a .214. does this represent the length the reamer cuts into the lands? is this the length of the slope? the bore is .219 and grooves are .224. thanks.
length of lands from start to complete elevation after reaming?
- Thread starter lpreddick
- Start date
Upgrades & Donations
This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.
Click Upgrade Membership Button ABOVE to get Gold or Silver Status.
You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.
To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.