• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Lapua 6.5 Creedmoor Brass Question

tclaunch

Silver $$ Contributor
Does anyone know a really close measurement of the neck wall thickness of this brass? I`m trying to spec a reamer. I`ve seen 2 prints so far in 6 Creedmoor which is why I`m asking with 2 different neck diameters .275" and .277"
 
Well has anyone even had the new Lapua 6 Creedmoor Brass in stock yet? The neck dimensions are likely different from necked down 6.5 vs the new Lapua 6 Creedmoor brass
 
I necked down Lapua 6.5 with a Forster FL Die, lightly turned the neck, and finished with loaded dummy round measured at .271

Dummy round befor turning was around .273
 

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Forum statistics

Threads
166,812
Messages
2,223,981
Members
79,861
Latest member
srak
Back
Top