L-N-L die and conversion bushings

[bbtoys]

Has anyone using the Hornady L-N-L die and conversion bushings noticed any problems with concentricity or seating depths? thinking about getting some to speed things up a little with my single stage press but didn't want to introduce any new variables. thanks

 

[markm87]

I'd be interested in this too. I just saw the conversion kit... didn't know it existed. I'm running the LNL classic single anyway.. but I'd be curious to hear....

 

[artbosco]

Has anyone using the Hornady L-N-L die and conversion bushings noticed any problems with concentricity or seating depths?

Once they're set up properly, None at all.

 

[nfhjr62]

The conversion kit will work on a RCBS press after the 7/8 14 bushing is removed ( hard work) saw this on www.ultimatereloader.com on a blog report.

 

[btm_54]

I have been using them for a few years. I have not had any problems. I used a sharpie to put an index mark on each die. L-N-L die and conversion bushings make change overs very quick.

 

[apakesha]

The only problem that I have is that the L-N-L shell holder will come undone from time to time. it is annoying to say the least. You decap and when you raise the handle the brass and shellholder coupled to the conversion bushing will all come out of its holder. It seems the O ring which is supposed to be the locker is not tight enough. I just bought a RCBS supreme with the 7/8 x 14 tpi die that will be my dedicated decapper.
For seating I use the Wilson Seater with the arbor press.