I have a Kimber 8400 WSM Montana chambered in 7mm WSM.
I dropped the gun while hunting and cracked the montana stock at the rear reciever screw.
So now I'm trying to decide where to go from here. I cant seem to find a replacement stock.
So my primary questions are:
-Are there any compatible inlets to the 8400 WSM reciever? It's longer than short action but not long action.
-Something that has the same spacing on reciever screws and recoil lug that I could relieve a little and epoxy bed?
-Are there any chassis that accept this reciever or compatible with slight modification?
-Are there any good prefit barrels for 8400?
-Are there any other manufacturers prefit barrels with same tennon thats compatible with 8400?
Ive been researching this for a couple weeks now and I'm not really getting anywhere with it. Any help is appreciated.
I dropped the gun while hunting and cracked the montana stock at the rear reciever screw.
So now I'm trying to decide where to go from here. I cant seem to find a replacement stock.
So my primary questions are:
-Are there any compatible inlets to the 8400 WSM reciever? It's longer than short action but not long action.
-Something that has the same spacing on reciever screws and recoil lug that I could relieve a little and epoxy bed?
-Are there any chassis that accept this reciever or compatible with slight modification?
-Are there any good prefit barrels for 8400?
-Are there any other manufacturers prefit barrels with same tennon thats compatible with 8400?
Ive been researching this for a couple weeks now and I'm not really getting anywhere with it. Any help is appreciated.