Mblmotors
Gold $$ Contributor
For sale a nice K&M priming tool with gauge and Lee Shell-holders. This tool allows you to precisely seat primers for each application.
This tool insures that you seat primers to the bottom of the primer pocket because it neutralizes the variables of manufacturing tolerances of primer height and primer pocket depth by measuring the depth of the primer pocket and referencing this to the primer height. This is accomplished when the primer seating rod acts as a probe to locate the bottom of the primer pocket while the dial indicator stem rests on the primer which is placed on the pedestal. To initially set up the tool install the proper seating anvil and shell holder for your cartridge. Next rotate the shell holder retainer nut so there is ample stroke remaining in the seating handle to properly seat the primer. This is best achieved by placing a primed case in the shell holder and squeezing the handle until it stops. The position where the handle stops should be in the general area as shown in the picture below. A good reference point to note is the end of the handle is near the bottom edge of the safety shield. Rotate the shell holder retainer nut as required to achieve this final position.
Full instructions are available at K&M site
Reduced
$90 shipped CONUS
This tool insures that you seat primers to the bottom of the primer pocket because it neutralizes the variables of manufacturing tolerances of primer height and primer pocket depth by measuring the depth of the primer pocket and referencing this to the primer height. This is accomplished when the primer seating rod acts as a probe to locate the bottom of the primer pocket while the dial indicator stem rests on the primer which is placed on the pedestal. To initially set up the tool install the proper seating anvil and shell holder for your cartridge. Next rotate the shell holder retainer nut so there is ample stroke remaining in the seating handle to properly seat the primer. This is best achieved by placing a primed case in the shell holder and squeezing the handle until it stops. The position where the handle stops should be in the general area as shown in the picture below. A good reference point to note is the end of the handle is near the bottom edge of the safety shield. Rotate the shell holder retainer nut as required to achieve this final position.
Full instructions are available at K&M site
Reduced
$90 shipped CONUS
Attachments
Last edited:
