jewel trigger

[lilgreg]

will jewel do repair work on their trigger i have one that is not acting like it supposed to 700 REM long mag action when it is cocked and you pull the trigger the trigger is solid don't move then you touch the bolt as to open the hammer falls i have sprayed out with brake cleaner aired out and then used lighter fuel then adjusted as on jewel page don't fall right but when i shorten up sear engage about 1/4 turn i could not get it to act up yet. could i have a rough sear and i have tried with 2 different firing pins and same results THANKS

 

[Immike]

Yes they will, the phone # 512-353-2999 You can mail it to them and within a few weeks they send it back. It's best to call first.

Jewell Triggers, inc
3620 Hwy. 123
San Marcos, TX 78666

 

[nosualc]

If you're somewhat adventurous and a bit handy, I would disassemble, clean and polish it. Once you get past the initial pucker factor, it isn't that bad. Take your time, take pictures with your cell phone as you disassemble it.

If you still have a problem you can send it to Jewell for a rebuild, and all you're out is a little time.

http://forum.accurateshooter.com/index.php?topic=3788411.0

-nosualc

 

[Joe Salt]

Had the same thing happen to one of mine, The main spring was bad! They will fix it .

Joe Salt

 

[tmwinds]

Try turning the overtravel screw in a little. Look at the instruction sheet that came with trigger for adj. instructions.

 

[lilgreg]

will took it apart made lot of pictures cleaned it up did not see no big problems put it back together works smooth like it should THANKS GREATLY for the help

 

[Immike]

will took it apart made lot of pictures cleaned it up did not see no big problems put it back together works smooth like it should THANKS GREATLY for the help

I keep a can of lighter fluid in my range bag for field cleaning. It's well worth it. Just flood the triggers a couple times and back in business. If it's just dirt.