Information needed, Nesika mod V barrel fitting.

[Rockhill Rifles]

I recently purchased a Nesika model V with magnum boltface. Upon inspection of the bolt configuration i realized that you do not cut a counterbore in your barrel. What is the min and max dimension between the end of the barrel and the end of the bolt?

 

[GNERGY]

I just did a Winchester with a flat bolt face and left .007 clearance.
Tarey

 

[Rockhill Rifles]

Thank you very much. Was not sure so I had to ask.
Thanks, Greg Wagner

 

[Rockhill Rifles]

I talked to speedy Gongales after the post and he me about the same. .005 to .010

 

[WSMNUT]

I cut all of mine like a Tikka or Winchester with a flat nose and took the dimension from the bolt nose to the bolt face which has been .135 on the few that I have done and added .010 for clearance so .145 above face is where I cut mine. I hope this helps.