Info on motor for Case neck turner

[AWLEAPHART]

I am going to build one and was needing help on HP, RPM and Torque.
I have been looking at used gear head AC motors and this is what I came up with.
HP 1/25
RPM around 100
Torque 20 in#
If you think one is too much or not enough please let me know. Most motors I looked at has a 1/2" shaft.
Thanks
Anthony

 

[Alex Wheeler]

https://www.amazon.com/dp/B000TKQ9P6/?tag=accuratescom-20
http://www.benchrite.com/cscart/index.php?dispatch=products.view&product_id=29789

 

[AWLEAPHART]

https://www.amazon.com/dp/B000TKQ9P6/?tag=accuratescom-20
http://www.benchrite.com/cscart/index.php?dispatch=products.view&product_id=29789

Thanks a lot ALEX. I was worried 20 inch pounds torque was to little.
ANTHONY

 

[AWLEAPHART]

This is the one I was looking at.

http://m.ebay.com/itm/Dayton-6A195B...%3A62b3b3fd1590a606414f366dffc911bf%7Ciid%3A1

 

[nbkky71]

Not sure if this will help, but here's site where you might be able to pick up a surplus motor cheap that meets your specs. One of my co-workers loves by this place.

https://www.surpluscenter.com/Electrical/

 

[mikegaiz]

100 RPM is good, but 20 in. # is not enough. I tried it and it will not work.

 

[rardoin]

I use a Bodine Electric 140rpm 35in-lb torque gear motor...plenty of torque. Model 0513. Bought it surplus but it still was not cheap. It powers a Wilson trimmer and turns the case holder for neck turning. I would look for 140 to 180 rpm as a good compromise between efficient speed for feeding fast enough to get a neck done fairly quick and still get a good finish while not generating too much heat in the mandrel.