I need help!!!

[Taube94]

Do you think ER Shaw would be a good place to take it to?

 

[shortgrass]

It looks like the metal work is complete. What you need, besides the mag box/trigger guard, is a gunsmith who will stock it for you. I will point out that the chambering is usually engraved on the barrel, not the receiver. ER Shaw is a barrel company. If their other work is like their barrels, I'd find a gunsmith to do the work. I'd have the chamber verified before proceeding with any stock work was begun (check headspace, test fire a couple of rounds into the dirt so I could examine the fired brass, etc).

 

[Taube94]

My dad was a machinist for America Airlines and he swore up and down by ER Shaw so I’m going to call them and see if my dad got the barrel from them.

 

[Taube94]

I finally got into a gunsmith and he said the same thing y’all said. He told me to get Mauser K98 parts

 

[Taube94]

In luck! I was at my dads place today and I found the bottom metal, trigger, and hardware!

 

[TAJ45]

Excellent end to the story.

 

[Taube94]

Little bit of elbow grease

 

[biggun2869]

If you REALLY care, get hooked up w/ G/MAC. He knows more about Mauser's than anyone I know of. And he will generally try to help you.

 

[spitfire_er]

Looks like it's getting there. Looks like he shaved the side of the receiver flat to allow for engraving.

 

[Taube94]

If you REALLY care, get hooked up w/ G/MAC. He knows more about Mauser's than anyone I know of. And he will generally try to help you.

Where can I get a hold of G/MAC

 

[butchlambert]

Ggmac on this forum.