Gunsmith with a Tight neck 300 wsm reamer willing to work on a Savage?

[loudandproud]

Hey guys,

So, Im in a looking to do a tight neck 300 wsm. Would a .337" neck give me a good clean up?

Does any one here know of a gunsmith that will do a tight neck 300 wsm on a savage target action? I would like to use either a hart or a kreiger and most of them only offer contours with a 1.20 breach. Will this be a problem for a gunsmith to setup? Has anyone here ran a set up similar to this before?

Any help would be apprectiated!

Thanks,

Bryson

 

[Raythemanroe]

My 300 wm is .339 necked and with Norma brass has about .003 clearance total or thou and half each side..I would think that you could take a thou off and be good after clean up but there is more experienced folks on here then me. Bob Green did mine

 

[Steve Blair]

Bob Green did all of my .300 WSM barrels. I supplied a Ø.337" reamer and turn to .012" thick neck for a loaded round neck Ø.332. That allows .005" diametral clearance. Works pretty well for me in F-Class.