Getting a 308 Bolt face with SAKO extractor to pull PPC

[accuracyman]

Going to barrel my XP-100 to PPC. The XP-100 currently has a .700 diameter Kiff coned bolt with .308 bolt face equipped with a SAKO extractor. Can the extractor be tweeked to pull a PPC. Not wanting it to eject just reliably pull a PPC.

One other question about the Kiff bolt and it's firing pin protrusion. I have a one-piece Kiff bolt with Kiff firing pin assembly. The protrusion measues .044" and I am concerned it is not sufficient. Is there an easy way to get more protrusion? The obvious way is to take a little off the firing pin stop but wanted to see how others address this issue.

Thanks,
Kris

 

[Chuckw]

I would open up the bolt and make a bushing to fit ppc head size. solder it in place and mill out the extractor cut again. I don't think there is anything else you can do. might be better to sell the bolt and get one set up for ppc.

chuck