WANTED (Found) Ken Light Anneal Plate 16s

[Bixahsheesah]

Looking for a 16s plate for a Ken Light annealer. (221Fireball, 17 Fireball, 17 Mach IV, ect). Please PM me if you have one you'd part with. Thanks for looking

 

[bozo699]

Looking for a 16s plate for a Ken Light annealer. (221Fireball, 17 Fireball, 17 Mach IV, ect). Please PM me if you have one you'd part with. Thanks for looking

His site is still up with a full listing of plates, idk if he is still in business but his site is up.
Wayne

 

[bozo699]

Products — CreateTech Precision Machine

www.createtechprecisionmachine.com

 

[Bixahsheesah]

His site is still up with a full listing of plates, idk if he is still in business but his site is up.
Wayne

Thanks, I'll check it out

 

[FNSafari]

His site is still up with a full listing of plates, idk if he is still in business but his site is up.
Wayne

I bought a plate about 6 months ago. Great to do biz with.

 

[Bixahsheesah]

If you have the standard case size shell plate holder. I cut 308 cases in half and stick the smaller cases in them.

I tried this: works pretty good but I couldn't load both pieces in fast enough to keep the plate filled. Also after a few rounds through the annealer them little critters are hot!

 

[pdog2225]

Hey Bix, here's the story on the ken lite annealer. In 2020 I needed a 16s plate for 6BR cases and I called the Ken Lite site. It seems that Ken had passed away and that Brian Crawford had bought back the annealer business. So I called Brian Crawford and bought the 16s plate from him ($80 dollars on 11-4-20. He was great to talk to and he shipped right away. here is the email that I used hope it still works.
(the crawfords2@gmail.com) no capital letters. Pdog2225 Good Luck

 

[Bixahsheesah]

Thank you sir!

 

[ricco1949]

I have a plate I made for 20 Vartargs for my Ken Light. It is 5/8 thick to expose more of the VT shoulder. It will work on any 221 FB based cartridge.

I will sell for $49 shipped.

Rick M.

 

[Bixahsheesah]

Thanks! I'll take it. PM incoming