fl resizing

[SPM]

Hey all, I have some once fired 6br brass and need to knoW what to do next. I'm going to buy a Harrels fl die but from what I have read it does not open up the neck to be resized, if this is true what are you guys using to do this step? Thanks, SPM

 

[billmo]

SPM, The die is suppose to close the neck a small amount to hold the next bullet. What you may be refering to is the die not having an expander ball. According to most BR shooters, better accuracy is obtained without the expander installed in the die. Bill

 

[SPM]

Thanks Bill, so what would I need to do in order to get rid of the dent left on my case mouth when I eject it? I assume this would have to be done prior to fl sizing. Thanks again, SPM

 

[billmo]

No, the die will take care of that when you run your brass thru it. Lube 1 pc. and try it. Bill

 

[SPM]

Thanks again Bill, this here newb appreciates it, SPM

 

[billmo]

You are welcome Sir. Anytime. Bill

 

[Preacher]

Thanks Bill, so what would I need to do in order to get rid of the dent left on my case mouth when I eject it? I assume this would have to be done prior to fl sizing. Thanks again, SPM

Relax that ejector spring a little and the dents will go away..