Finally a new batch is ready!

[boltfluter]

Hey guys,

After numerous requests, I finally found the time to make another run of recoil lugs. This time I ran 130 pieces, as I ran out of lugs in two weeks last time with a run of 75. These are very nice stainless lugs with a 1.065 through hole, that is chamfered on both sides. .250 thick. Flat and parallel within .0002 or better. A nice face chamfer around the outside profile makes for a nice finished look. Priced at 29.95 + 5.00 shipping these are very reasonable compared to a Holland at $50 plus. These are a little shorter than a Holland and will fit in all chassis without having to shorten the OAL. I major complaint with the smiths that I spoke with. Please consider these for your next build.

Gunsmith discounts are available, just ask.

Thanks guys,

Paul

 

[jobhopper66]

First rate work as always Paul. Your talent never ceases to amaze me!

 

[Dusty Stevens]

Do you make the lug alignment jig to align them while tightening the barrel if not using ze pin? Do you make the jig to drill ze pin hole in the action? Im in need of recoil lugs right now actually