Elisio Tube Gun

[6and7mm]

Does anyone know a couple of good options for an forearm adapter to use a Harris bipod with the Elisio stock?

 

[watercam]

I am sure Gary has an adapter but if not Sinclair has a forearm rail adapter with a swivel stud that should work.

 

[6and7mm]

Thank you!

 

[USMCDOC]

I am sure Gary has an adapter but if not Sinclair has a forearm rail adapter with a swivel stud that should work.

They do.. and you will have to mill it to fit the slot

 

[Rustystud]

Take a look at Gary's Tube Gun bipod. It is very hard to beat.

 

[284driver]

I simply used the picatinny rail from Gary and attached a swivel bipod adapter then attached the harris

 

[Exercion]

Assuming your fore end has the slot for the handstop, and nothing has changed since I bought one, this is not a difficult thing. I have one, and there are two slot widths, Winchester/Freeland and Anchutz. I do not recall which Mr. Eliseo uses (I think the Winchester one) but I simply ordered that dimensioned Harris bipod adapter. Pretty much anyone who sells one size sells the other.

Eric

 

[6and7mm]

Thanks for the insight!

 

[moondog]

I just tapped the aluminum tube and threaded a swivel stud in mine for the harris

 

[Xkv8r]

Sinclair sell a very small stud that slides into the slot on the bottom of an R5. You first attach it to the harris and then slide it into the slot. Works very well, but I eventually sprung for a picatinny rail.

https://www.sinclairintl.com/shooti...spx?avs|Manufacturer_1=sinclair+international