• This Forum is for adults 18 years of age or over. By continuing to use this Forum you are confirming that you are 18 or older. No content shall be viewed by any person under 18 in California.

Drill Press

themayor

What is everyone think about using a drill press to aid in brass prep like neck turning deburring and stuff like that. I tried searching but didnt find much
 
How slow can you slow er down to? To have a nice variable speed press you could remove the AC motor off of a cheapie drill press and replace it with a 100Volt Bodine or equal 1/8-1/4hp 2500rpm DC motor. You will also need a speed control for that size motor. I've bought several of the above on Ebay for $10-$25 you just need to be patient. Search DC MOTOR and you'll find something.
 
You must log in or register to reply here.

Upgrades & Donations

This Forum's expenses are primarily paid by member contributions. You can upgrade your Forum membership in seconds. Gold and Silver members get unlimited FREE classifieds for one year. Gold members can upload custom avatars.


Click Upgrade Membership Button ABOVE to get Gold or Silver Status.

You can also donate any amount, large or small, with the button below. Include your Forum Name in the PayPal Notes field.


To DONATE by CHECK, or make a recurring donation, CLICK HERE to learn how.

Classified Ads

Forum statistics

Threads
165,800
Messages
2,203,708
Members
79,130
Latest member
Jsawyer09

Share This Page

Back
Top